Mud Reports Samples For Students

Part A

Process, SEQ Water (2016)
The flash tank: The water from the river flows to the flash mixer where it is mixed with caustic soda and alum chemicals. The rate of chemical used depends on some sediments and wastes contained in the water.
Flocculation chamber: In the flocculation chamber, smaller chemical particles undergo a gentle mixing process allowing them to mix and form large particles known as floccules made up of clay and silt. Floccules enter the sedimentation tank and settle at the bottom of the tank where they are separated and pumped out of the sedimentation tank through a ...

Oil exploration is a multifaceted process that requires careful planning. Environmental experts state that there is a need to conduct environmental impact assessment (EIA) prior to commencing the exploration process. Environmental impact assessment process begins with the identification of issues and impacts that are likely to be important and the establishment of terms of reference for the EIA. Secondly, there is the identification of alternatives; in this case, environmentally sound and benign options are identified. Thirdly, EIA involves impact analysis. This involves the identification and prediction of environmental, social and other effects of the exploration process. Fourthly, there is mitigation and ...

Introduction

The coastline that stretches from Hastings to Cliff End is dominated by cliffs exposing a significant proportion of the Ashdown Formation. Notably, the cliffs stretching from East Hill in Hasting to Pett Beach that are approximately 7.5 km to the East north-east have been distinguished as Site of Special Scientific Importance (SSSI) due to its geological interest. Evidently, the cliffs exhibit most absolute sequence of terrestrial Lower Cretaceous rocks and form the principal exposure of the of the renown Ashdown Formation. In this area, the Ashdown Formation is preserved in low amplitude of the Fairlight Anticline which cuts the coast ...

Engineering

Abstract
The Brooklyn Bridge is probably underappreciated by most of the people who use it today but it is still an example of great engineering. The chief engineer, Roebling, designed a suspension bridge that was fifty percent longer than any other suspension bridge of the times. His design for weighting of the bridge to keep it stable when there was wind is a very important lesson for today’s suspension bridge designers. The health and safety issues of the height of the bridge and the use of the Caisson boxes have been discussed. The approximately 27 deaths that took place ...