Essays on Second Moment Of Area

Abstract

The experiment involved the investigation of the young’s modulus of different beams made from different materials. The beams that were used for the test were steel, aluminum and timber. The experiment involved placing of the beams on the measurement machine shown below and addition of loads at the center of the beam. The loads were then varied across the beams while investigating the relationship that existed between the beams when different loads were added. The height, width, and the respective deflections were therefore recorded for analysis. The dial gauge was used to measure the deflection of the beam ...

Abstract

In this experiment, the young modulus of three beams was investigated these were steel, aluminum and timber. The beams were placed and the deflections values upon addition of various loads at the Centre of the beam taken. There was a variation of the loads across the beam to investigate thee relationship that existed between the loads, the span width, height, and deflections. Measurement of the deflection was therefore done through the dial gauge with three sets of measurements being taken and the average calculated. Different beams were used to enable elaborate comparison of the coefficient of elasticity. Measurement of ...

Abstract

The aim of this experiment was to determine the relationship between the Young’s Modulus and the deflection of a beam. Since different materials have different values of Young’s Modulus, the students selected three different materials for the experiment. In this case, the materials used include timber, aluminium, and steel. All the materials were identical in terms of the dimensions such as width and length. The each beam of the three materials was subjected to some magnitude of force at the centre and deflection measured. Data concerning the magnitude of load and the corresponding defection were then gathered ...

Introduction

Bend (flexure) testing is often done in springs as well in brittle materials whose behaviors of failure are linear like concrete, wood, plastic, glass and ceramics. Bend testing is suitable for evaluating the strength of brittle materials where the results of tensile tests aren’t easy to interpret due to the breaking of specimens around the gripping (Schoffstall, Charles, and Robert 234). In bend testing experiment, smooth rectangular specimens without notches are recommended under three or four point bend arrangements. Figure I below illustrates three point and four point bend arrangements respectively. Figure 1. Bend testing of a smooth ...