Part 1 Analyzing a Simple RC Circuit
1-2. A snapshot of the circuit built in Multisim is shown in the following figure:
3-6. The function generator’s output is set to the following: sine wave, frequency of 1 kHz, and amplitude VPK = 5 volts. Then, an oscilloscope is added to measure the input and the output voltages. The circuit in Multisim is shown in the following circuit diagram:
Upon running the simulation and adjusting the oscilloscope settings, the following output waveform is displayed in the oscilloscope interface:
7-11. The oscilloscope cursors are adjusted such that the time difference between the two traces are measured. This is done by setting the first cursor to the maximum of the first waveform, and then setting the second ...