Stacking Reports Samples For Students

123 4th Avenue

New York, New York

USA 547890
Dear Mr. Green:
Safety and health is crucial in every endeavor. As such, conducting tasks analyses in a work setting is paramount to ensuring that the health condition and safety of all personnel are taken into utmost consideration. As such, in response to your request, I am hereby documenting the “Task Analysis – Ergonomics Report” which summarizes the results of the recently conducted task analysis – ergonomics assessment on a specific job at your convenience store, that of a Shelves Stacker, which was conducted on October 23, 2014. The report contains relevant information which includes a summary of ...

Aim: To separate Green Fluorescent Protein (GFP) using poly-acrylamide gel electrophoresis (PAGE).

Introduction: Bioluminescence observed in many marine organisms is due to a protein called as Green Fluorescent Protein (GFP). Since its discovery, GFP has been useful in biotechnology due to its versatility and ease of transformation in E. coli (Chalfie et al., 1994). GFP is a 26.87 kilodaltons (kD) protein composed of 239 amino acids. It has a barrel structure with a fluorescent chromophore embedded deep in the interior of the protein. The chromophores in GFP are excited at a wavelength of 395 nm, and when the electrons of chromophores drop to a lower energy state they emit fluorescent light of 509 nm (Ormo et al., ...

Introduction

Bend (flexure) testing is often done in springs as well in brittle materials whose behaviors of failure are linear like concrete, wood, plastic, glass and ceramics. Bend testing is suitable for evaluating the strength of brittle materials where the results of tensile tests aren’t easy to interpret due to the breaking of specimens around the gripping (Schoffstall, Charles, and Robert 234). In bend testing experiment, smooth rectangular specimens without notches are recommended under three or four point bend arrangements. Figure I below illustrates three point and four point bend arrangements respectively.
Figure 1. Bend testing of a smooth ...

Introduction

Autonomous guided vehicles are also referred to as automated guided vehicles or automatic guided vehicle. Its robot which follows wires or marks in a flow or any other surface that it may be guided through. They are commonly used in industries to carry materials around warehouses and other manufacturing facilities. This is useful in area where it could be difficult for human beings to carry loads. Automatic vehicles can also be applied in exploration work or where there is possibility of damage. They are used for electrical installations as well as navigation through hazardous areas especially those suspected to be ...