Clockwise Reports Samples For Students

Introduction

The fiber optic systems are systems which use light as a mode of communication. The system includes fiber cables which allow for the transmission of light through them. Inside the cable are special coatings for protection and also to enable the transmission of light through total internal reflection (Hoss and Lacy). The light is then converted into electrical signals through the use of light detectors having in mind that the signal was produced by a light emitting diode. The use of optics is very wide since the use of light is much more efficient and also flexible being that ...

Lab Report 7

Introduction
The electrical motor is the device, which converts electrical energy into the mechanical energy. It is must to analyze the characteristics of electric motor. The electric motor is always considered as the dynamic device, which changes its performance influenced by various factors. It is necessary to analyze the important electrical parameters of the electric motor, in order, to use the electrical motor for the particular applications. The electric motor is used in the applications like pumping, home appliances, lifts, cranes, etc. This report discusses about the construction of the electrical motor, and mainly, it discusses about the ...

Final Exam Geology

Patterns of Surface Ocean Currents

Surface currents are found in the upper four hundred meters of an ocean body and they form major patterns such as eddies, upwelling, and gyres (Garrishon, 2007). Surface currents result from wind energy that is concentrated in both north and south hemispheres forming trade winds which are easterlies and westerlies (Garrishon, 2007). Waves on the sea surface transfer some of the energy from the moving air to the water by friction. Pulling of wind on the surface of ocean causes an accumulation of water with the water displaced underneath the wind forming the movement.
...

Lathes are being used since a long period of time and tooling and designing method, and the purposes for which it has been used most of the times are drilling and boring holes that are usually conical or cylindrical in shape. The manual lathe usage primarily depends upon the machinist and the experience in the designing field. With time there has been a major improvement in the efficiency and quality of part development, which is a result of numerical control into the process of tool designing and the use of lathe. The most advanced and the latest technique in this area is ...