Dial Reports Samples For Students

Abstract

The experiment involved the investigation of the young’s modulus of different beams made from different materials. The beams that were used for the test were steel, aluminum and timber. The experiment involved placing of the beams on the measurement machine shown below and addition of loads at the center of the beam. The loads were then varied across the beams while investigating the relationship that existed between the beams when different loads were added. The height, width, and the respective deflections were therefore recorded for analysis. The dial gauge was used to measure the deflection of the beam ...

List of Figures

Figure 1 Washing Machine FSM diagram 5
Figure 2 CD FSM 7
Figure 3 Original figure for CD FSM 10

List of Tables

A state in the vocabulary of FSM technical terminology is all the stored data at any given point in time for which a process can be accessed (or controlled) by the program (Chaandrupatla and Delegundu, 2011).. In terms of a washing machine a state can be the washing cycle at a low temperature. In a coffee dispenser the state can be the point in a process where change (if appropriate) is returned to the user. An input plus ...

Abstract

In this experiment, the young modulus of three beams was investigated these were steel, aluminum and timber. The beams were placed and the deflections values upon addition of various loads at the Centre of the beam taken. There was a variation of the loads across the beam to investigate thee relationship that existed between the loads, the span width, height, and deflections. Measurement of the deflection was therefore done through the dial gauge with three sets of measurements being taken and the average calculated. Different beams were used to enable elaborate comparison of the coefficient of elasticity. Measurement of ...

Executive Travel Report

Tel Aviv
Tel Aviv (Israel) Fast Facts
Status Financial center of Israel and 2nd most populous city
Time zone UCT/GMT +3 hours

Political system Democracy

Main religion Judaism
Language(s) Hebrew, Arabic, English
Currency exchange rate 1 ILS = 0.26 USD; Inverse 3.76 USD

Arriving to Ben-Gurion International Airport (Tel Aviv)

The airport is located 20 km (12.5 miles) outside the city. Equipped with 3 terminals, the airport is designed to service approximately 16 million travelers a year. You will arrive to Terminal 3 that accepts international flights. Inside the terminal you will find an emergency clinic, post office, currency exchange centers, 24 hour banks and a number and of ...

INTRODUCTION

Consolidation is a process which involves a decrease in water content of saturated soil without replacement of water by air (Terzaghi 265). During the process, two changes occur: (1) reduction in soil volume and (2) increase in soil strength. The results of this test are used in the study of fine-grained, cohesive soils such as clay and clay-silt. Generally, an undisturbed sample is fitted into a consolidation device.
This consolidation device consist of a heavy brass metal ring to hold the soil sample being tested and porous stone discs to cover the top and bottom surface of the sample. The discs enable ...

I present this unsolicited proposal guided by the third Guiding Principle of your foundation; the principle which states that science and technology have great potential to improve lives around the world. I herein seek for grants to enable me start a project aimed at improving access to ICT in Chad.

It is my hope that your Foundation finds the proposal feasible and that you support me in quest to achieve the objectives which, I believe, complement your Foundation’s.

Executive Summary

Chad is one of the poorest countries in the world. As a consequence, its adoption of ICT is very low. This is ...

Abstract

Materials exhibit different chemical and mechanical properties such as strength and durability. Combining different materials to form a material composite enhances their individual properties in different measures. In this experiment, the mechanical strength of composite sandwich structures was investigated through bending. Four samples were investigated for their properties on bending and strength. Three of the four polystyrene beams were reinforced with paper while the fourth beam was investigated without paper reinforcement. One of the beams was bonded with construction paper on one side; the next bema was bonded with construction paper on both sides while the third beam was ...

The use of collinearity in imaging is a very versatile technique for image correction. The process is applicable in taking of picture using sensors from above the ground. The science behind the process is helping in converting several images taken into an orthographic image format. The camera does a transformation to a 3 x 3 matrix system which removes relief from the picture and making it machine readable. This form of change does its conversations within the ranges of changes in the X Y and Z axes of telemetry (Han, Guo, and Chou 313-316). The imaging dimensions taken have ...