Essays on FEA

Lab Report

The objective of this paper is to illustrate the experiences in the classroom during the demonstration of a pilot section.

Introduction

The Engineering Design Graphics (EDG) course included the engineering analysis for incorporating the new CAD component in to the computer laboratory. The students were required to construct two solid models that match in terms of their profiles, however they differ slightly in terms of their geometry as shown below: Figure 1: Rocker arm solid model of the rocker arm used for studying, producing, and comparing .MPR files (mass-properties report files).

The students ...

International Marketing Report

INTRODUCTION Marketing the product through proper strategic approach to facilitate the customers in a given area is the critical thread for any international company (Ghauri, & Cateora, 2010). The working purpose of the marketing project is to analyse AACo’s current situation, its target market in India, determine strategies for reaching potential clients and develop marketing tactics. The marketing project opens with an analysis of the company's situation analysis, including detailed Pest analysis of Indian market. Further, the report determines its major competitors in India. Hind Agro Industries Limited and ALM Industries Limited are the main competitors with the strong customer ...

#222060 : Finite Element Analysis of a Clamp Frame

PART 1 INITIAL STRESS ANALYSIS

Analysis Model is prepared with the dimension as shown in Fig.1-1 Fig.1-1 Initial Specification

Material propertie as shown in Table1-1 is adopted in the model.

All the degree of freedom is fixed at the lower platform, as shown in Fig.1-2; Fig.1-2 Boundary Condition at the Lower Platform

Upward axial force (15000N) is applied on the inner surface of the cylindrical hole, as shown in Fig.1-3;

Fig.1-3 Axial Force at the Cylindrical Hole

Mesh is created with a default size, as shown in Fig.1-4;

Fig.1-4 Mesh with a Default Size : 12481 Nodes / 7372 Elements

After the calculation, the following results are obtained;

1. A Stress Plot of the von Mises Stress for the entire frame, clearly showing the area of highest stress. Fig.1-5 Von Mises Stress : Max. Stress = 204.382(Mpa) 2. A plot of ...

Continental Congress adopted this statement on July 4, 1776. It announced independence of the thirteen colonies of America, which were under Great Britain, and thus they had then formed the USA, which was then a new nation. John Adams became a vibrant leader in struggling for independence, and it was approved in July 2. The document had already been drafted by a committee of the congress voting on independence. The Independence Declaration was not primarily written to guard the "self-evident" fact that all human beings were created equal and thus they possess rights that are unalienable (John 1). It is much ...

This report presents the static analysis of a beam that is going to be used for lifting equipment in a building. A commercial software package, SolidWorks, is used to perform a set of FEA simulations. Numerical results are compared with theoretical values of maximum stress and deflection for a cantilever beam. 1. Part A The first part of this report describes a cantilever beam with one end fully constrained and a point force of 5 kN applied at the opposite end. Three cross sections are considered, namely, a wide flange section (I-shape), a T section and a channel cross sections. The beam is made of Mild ...