Inverse Reports Samples For Students

1.1 Introduction
In typical industrial applications, the machines and equipment involved require high electrical ratings, like high voltages and high currents. Different machineries have varying voltage and current ratings. These ratings should be followed in order that the equipment operates properly whenever needed. However, undesirable conditions, like voltages and currents above the prescribed ratings (usually called as faults), are not totally unavoidable. In these conditions, damages on the machinery might occur which can cause production issues and problems, and may even be hazardous to humans. These conditions can be avoided by integrating protective circuitry within the electrical systems.
...

Exercise 1

Particular features of the Fourier Image
- The Fourier analysis of the images in pre-set preview form the run program showcase the transformation action performed on the image. From the exercise one lab program the Fourier image shows how one can gain access to the geometric features of the real domain imagery from the original image.
- The particulars of the Fourier imagery from the image previews are lifted in such a way that image mean, otherwise denoted to as the DC-value is shown in the middle part or focus of the imagery.
- The Fourier image ...

BERNOULLI’S EXPERIMENT

ABSTRACT
Two fluid properties, the Bernoulli principle and the Venturi effect, were examined and analyzed in this experiment. A venturi meter was used to measure the fluid flow rate, velocity, and pressure of water (the fluid being examined). The results showed that the fluid pressure decreases as the fluid traveled through a smaller cross sectional area. The minimum fluid pressure (in effect, maximum fluid velocity) was observed in the smallest cross sectional area at position D (diameter 16 mm). The decrease in fluid pressure was compensated by an increase in the fluid velocity. With these two measured phenomena, both ...

Executive summary

The aim of the report was to determine the consumption pattern as well as the magnitude and direction of the correlations of various inputs in the production process of aluminum grade. Effective control of inputs cost is a result of efficient analysis. Therefore, the report analyzed the electrical as well as chemical and plumbing to compare their respective amount and standard deviation. The study showed that the process produces more plumbing and chemical grade as compared to electrical aluminum grade. Again, the report probed on the appropriate purchase amount for the alumina against a set value. Statistical analysis confirmed ...

Abstract

The experiment aimed at monitoring the change in volume of a gas in a confined container as the pressure on the gas was being increase. The experiment successfully demonstrated that volume decreases as the pressure on gas is increased.

Introduction

Boyle’s Law involves the relationship that exists between volume and pressure of an ideal gas, assuming that the mass and temperature of the gas is held constant. The law is stated that for a fixed ideal gas amount kept at a fixed temperature, pressure (P) and volume (V) are inversely proportional. This means that when one parameter is increased, the other one decreases. ...

Abstract

The experiment aimed at explaining the interaction of the molecules at different pressure, temperature and volumes. At low temperatures, the volume of the gas was low while at high temperatures, the volume of gas increased. The experiment successfully determined the value of absolute temperature using the Charles’s Law as 202.75OC which was lower than the theoretical value. The experiment also successfully verified the Boyle’s Law. The interaction of temperature and the volume of the fluid can be concluded to be directly proportional with an increase in temperature leading to increase in volume. On the other hand, the ...

Introduction

The relation between the potential difference, electric current, and resistance are represented in the Ohm Law. The Ohm Law consists in the direct relation between the potential difference and the electric current of a basic circuit, where the resistance is the constant value in the relation. Mathematically speaking the Ohm Law is a first-grade equation where the potential difference is the dependent variable, the electric current the independent variable and the resistance a constant value.
With a deep analysis of the circuit, the resistances are components inside the circuit that difficult the path of the electric current through the ...

Executive Travel Report

Tel Aviv
Tel Aviv (Israel) Fast Facts
Status Financial center of Israel and 2nd most populous city
Time zone UCT/GMT +3 hours

Political system Democracy

Main religion Judaism
Language(s) Hebrew, Arabic, English
Currency exchange rate 1 ILS = 0.26 USD; Inverse 3.76 USD

Arriving to Ben-Gurion International Airport (Tel Aviv)

The airport is located 20 km (12.5 miles) outside the city. Equipped with 3 terminals, the airport is designed to service approximately 16 million travelers a year. You will arrive to Terminal 3 that accepts international flights. Inside the terminal you will find an emergency clinic, post office, currency exchange centers, 24 hour banks and a number and of ...

Analysis of Plant Pigments with Liquid Chromatography and Spectrometric Detection

The experiment is aimed at coming up with a solution of knowing on how to separate color pigments in a mixture of some solvent. An appropriate solvent is put into use and then some conclusion is drawn from the observations made. The following could be the

- The extract becomes darker progressively due to the fact that the spinach solution becomes more concentrated with the subsequent extractions of the acetone solution. It is observed that the extracts starts at around 10ml of the organic solvent, but as the experiment proceeds, the volume becomes 2.0ml which was almost as the same volume ...

Rockets and newton’s laws of motion

Rockets and newton’s laws of motion

Introduction.

The movement of a rocket from the surface of the Earth to an arrival on the Moon can be clarified and depicted by physical principals found more than three hundred years back by Sir Isaac Newton. He worked in numerous regions of math and material science. He added to the speculations of attractive energy in 1666, when he was just twenty three years of age (Loeschnig & Zweifel, 1999). Newton's first law expresses that each item stays very still or in uniform movement in a straight line unless constrained to change its state by the ...

Project Title: Selection Materials

Module Code:
Project Due Date:
DCU Statement
Plagiarism means presenting another person’s words, ideas, designs as your own word. Plagiarism comes in a different form, like copying text, diagram, formulae, etc. Plagiarism is a serious offence. Plagiarism is referred to the disciplinary committee of the university. Committee will take the serious action on the plagiarized materials.

Aim and Objective

This project is being aimed to model the stress the board by considering a typical beam supported by the equal pressure on the bottom and it must withstand a point force.
1. Introduction
The material selection is the process of designing a ...

Part 1)

Analyzing financial statements of the company is of great importance as it serves different purposes of each interested party. For Instance, while investors analyze the financial statements to evaluate their investment decision in the company, creditors are more concerned to judge the profitability of the company i.e if the company will be able to honor their agreed payments on time. Apart from these outside parties, even the management of the company conduct financial statement analysis so as to formulate future plans and decisions.

However, there are different tools available for supporting the financial analysis of the companies and the same are discussed hereunder:

Vertical Analysis: A popular method of conducting financial statement analysis in which each entry of the ...